peartree
Very simple request- Curve adjust for flex track that allows for more than a 90 degree bend. Please limit the bend to the actual length of the piece of flex.
A suggestion would be that if you're using the Atlas code 80 N scale slex track #2500 and you enter a curve of 135 degrees at a 22 inch radius, the program calculates that you will run out of track after 108 degrees of curve, then have the program replace the 135 degrees that you've entered with the max available amount of curve. Also flash a short warning that you've hit the limit of the track piece at that amount of curve (just so people who might get very wrapped up in designing that they don't pay attention will see their mistake).
Thanks
David
Unfortunately, this is not really easy.
AnyRail represents flex track with Bezier curves. It's not possible to shape them into a (near) perfect curve for angles greater than 90 degrees. This restriction of the computerized flex track makes it a bit difficult to implement.
Also, for curves like that, you should take into account the different lengths for the left and the right rail (the inner rail is significantly shorter than the outer rail).
My own experience with flex is that it's quite difficult to bend it into perfect curves beyond a certain angle. If you want perfect curves, you'd better use the sectional curves (if available for the required radius).
Also, it's a lot easier to cut both rails of the flex once you've put it into place. It's almost impossible to first cut it and then lay it. Sometimes it's even a good idea to take advantage of the inner rail sticking out, not cut it, and make a 'shifted?' connection, like this:
-------------|--------
------|---------------
It 's easier to make a smooth curve using that technique.
David.