RichardTonkin
Is there an easy way to set an item which I have rotated so that the vertical lines are vertical and the horizontal ones horizontal again?
I can achieve the effect by blowing up the image size and lining it up, by eye, so it is aligned with the grid lines but it seems to me there may be an easier way.
BritsTukker
If you realise you've done it wrong quick enough, you can just hit the 'undo' button........ (you can 'undo' quite a few steps)
Assuming you're beyond the point of no return, then I'm not aware of a better way than what you're doing. Sorry.
RhB_HJ
Note on that "undo" function (Ctrl+Z): don't do it too rapidly or AR could lock up on you!
RichardTonkin
Sorry, I didn't express the problem very clearly. What I meant was having drawn it using Add Rectangle so it is aligned properly, to get back to that state in a later session.
By the way, Undo is one of my favourite buttons - very useful for doing 'what ifs'.
glakedylan
if saved earlier session just copy and then paste into new session
if not saved, as far as i know, you will have to go through each of the steps you did to get it the way you had it previously.
hope this helps
Gary
David
@RhB_HJ: that problem was solved in update 4.25.
David.
peartree
Personally, if I had to make sure that the shape was back in shape, I would set the Snap to grid to some value that fits the shape (i.e. set it to inch grid if the shape is 2 x 4 inches, etc.), then check the box to turn it on. It should snap to the set points. Or, you could certainly just insert another box, seeing as how it's easy to do.
glakedylan
greetings Jeff...yes! that is one of the better things i have learned.
even if it is just for one structure, and it being of a footprint with size into the 1/8 of inch
i set the snap to setting so that it will go exactly where i need it to be.
thanks for the input! much appreciated!
sincerely
Gary L Lake Dillensnyder