jphbuisson Hello David First of all, many thanks to you and your team for the rapid implementation of the 'cut flex here' scissor you made (following a previous mail sent on that subject). Your program is a real pleasure to use for us! ;D As I enter now the real implementation phase (on the wooden base) of my large rail layout, I would appreciate, as others already mentioned it I beleive, a very small 'plus' but very useful for this phase of transfer: > that is the display of the center of curvature of the 'flex-curved sections' and especially the display of their Cartesian coordinates! With such information, precise manual drawing and transferring on the wooden base would be much more simplified...(in my personal case, my layout has a total of 54 meters of flex rail with 30 critical true arcs to draw precisely -minimum radius permitted- ..) You already got the necessary information for these centers in the related member variables of your program, so it shouldn’t be too hard a task to bring it out ? ;) The display of this information could be optional (available only for an already selected ‘curved flex’ for example) > a richer variant would be to bring this same information at any junction point ( there would be 0, 1 or two centers per point in that case, depending on the 2 adjacent radii). This information could be optional also (available only for an already selected junction point, for example)so as not to overload the display. This would be extremely valuable for people like me using exclusively flex rail material. Here also, this information should be already available to you somewhere in your member variables… Thanks for your paying attention to us, end- users of your excellent work… Sincerely yours. Ralph JP BUISSON
peartree I'd like to amplify or extend the request (which I, too, have put in here before). I think that curve centers should be displayed at all times (as a circle of the same diameter as an end point, with a pair of crossed lines). Then, when the mouse pointer is hovered over one of these arc centers, a line will appear leading to the arc center point of the arc. Or, if you select a piece of flex track, all the connected lines to curves of that piece of track should show.
RhB_HJ .................. (I actually DO have hair, btw...) Yeah well, all it will take is planning a few layouts with KATO track and that statement will be toast. ::) ::)